AC Running but Not Cooling? What to Check Before a Service Call
If your air conditioner is running but the house is still warm, a few safe checks can help separate a simple airflow or thermostat issue from a problem that needs professional diagnosis.

Start with the thermostat and the obvious settings
Make sure the thermostat is set to COOL and the temperature setting is below the current room temperature. If the thermostat uses batteries, a weak or blank display is also worth checking. If the indoor fan runs but the home is still getting warmer, note that symptom because it helps narrow the diagnosis.
Check the air filter and visible airflow
A heavily loaded filter can restrict airflow and contribute to weak cooling or coil icing. Check the filter that is intended for homeowner access and replace or clean it according to the equipment and filter instructions. Also make sure supply registers and return grilles are not blocked by furniture, rugs or stored items. Do not open an equipment cabinet just to reach an internal filter or coil.
Look at what the indoor and outdoor equipment are doing
Without removing panels, observe whether the indoor blower is moving air and whether the outdoor unit appears to be operating. Keep leaves, grass clippings and other loose debris away from the outdoor equipment. Buzzing, repeated starting attempts, a stopped outdoor fan or other abnormal operation can point to an electrical or mechanical problem that needs professional testing.
Ice changes the next step
If you see ice on the refrigerant tubing or signs that the indoor coil is frozen, switch cooling off rather than forcing the system to keep running. A dirty filter can contribute to freezing, but refrigerant, airflow and component problems can create similar symptoms. Read GEM’s guide on why an air conditioner freezes up for safe first steps. Do not use a torch, hair dryer or sharp tool to remove ice.
A tripped breaker can be a clue, not just an inconvenience
If you are comfortable checking the electrical panel, look for a clearly labeled HVAC or air-conditioning breaker that has tripped. A single reset may restore power, but if the breaker trips again, leave it off and schedule service. Repeatedly resetting a breaker can mask an electrical fault and is not a repair.
What not to troubleshoot yourself
Refrigerant charge, capacitor testing, contactors, high-voltage wiring, compressors and sealed-system repairs require the right tools and procedures. Do not add refrigerant based only on warm air, bypass a safety control, install a larger fuse or breaker, or open live electrical compartments. The symptom tells us where to start, but measurements are what identify the cause.
When to stop troubleshooting and call
Schedule professional diagnosis if the thermostat, accessible filter and obvious power checks do not resolve the problem, or if cooling returns and then fails again. Shut the system down and call sooner if a breaker repeatedly trips, you smell burning, water is reaching electrical equipment, the system is icing, or the outdoor unit is making severe or unusual noises.
What information helps during the service call
You do not need to diagnose the equipment before contacting GEM. Helpful observations include whether the thermostat is calling for cooling, whether the indoor blower and outdoor unit are running, whether airflow is weak, whether you see ice or water, and whether a breaker has tripped. Those details help us focus the visit without asking you to open the equipment.
How GEM approaches an AC that is not cooling
We diagnose the operating condition before recommending a repair. Depending on the symptoms, that may include airflow, electrical, temperature, condensate and refrigerant-side checks using the appropriate procedures. We explain what was found, what needs attention now and what can reasonably be monitored before you approve repair work.
A cooling repair in Bondurant
On a summer cooling repair visit in Bondurant, we cleaned the indoor evaporator coil and blower wheel and replaced a dual-run capacitor. The cleaning addressed the air path. The capacitor was a separate electrical repair on the same visit. If your house is staying warm, tell us whether the airflow at the vents has changed.
U.S. veterans and customers age 65 or older can save 10% on qualifying residential HVAC repairs. Mention the offer when you book.
Frequently asked question
Why is my AC running but the house is still warm?
Possible causes range from thermostat settings and restricted airflow to a dirty outdoor coil, frozen indoor coil, refrigerant problem or failed electrical or mechanical component. The safe homeowner checks are limited. If the system is running but indoor temperature keeps climbing, professional diagnosis is the fastest way to separate an airflow issue from a refrigeration or component problem.
Related GEM service pages
Air conditioner repair | AC maintenance and tune-ups | Air conditioner services
Related HVAC guides
Continue with GEM’s guide on why an air conditioner freezes up and what an HVAC tune-up should include.
Talk with GEM Heating & Cooling
For AC repairs, tune-ups or a replacement estimate, book online with GEM. For the fastest response, especially after hours, call (515) 867-9366 to discuss current availability.
